Note: All prices are ex-works and exclude V.A.T. Based on prices April 2004

Product Description

These kilns have been developed to meet a growing demand for a good quality, efficient top-loading kiln for use at up to 1300°C, operating with a minimum heat loss and a sensible outside casing temperature.  The kilns are compact in design with detailed attention paid to both the construction and the quality of materials used.  The casing has a double skin with air-gap.  The inner skin is stainless steel to give added protection against corrosion.  The kiln is fully lined with low density brick, including the lid.  The brickwork is of dry lined construction for ease of replacement.  The lid is fitted with gas springs on models T50-T80 (optional extra for other models).

Heating elements are inserted in all four walls terminating behind the hinged front control panel.  All electrical repairs can thus be carried out from the front.   All models are available in single phase or 3-phase + neutral versions and are covered by our 1-year warranty.

When planning the installation of a kiln attention should be given to the size of the kiln room, floor strength & ventilation requirements.  Space should be allowed to enable the kiln to be manoeuvred into position and to meet the minimum clearance distances.  The floor must be level and strong enough to support the weight of the kiln and its workload.  If sited in an enclosed space forced ventilation is recommended.

Minimum clearance distances are:-

Above:    1000mm    39"

At side:    150mm    6"

At rear:    150mm    6"